Crestgolf Golf Putter Plane Laser Sight Golf Training Aid-Fix Your Putt in Seconds

Product Description

For a perfect stroke path, the Laser Putting Guide makes it very easy to visually check alignment and evaluate stroke by using a laser beam guide device. It’s a great training aid for golfers of all levels, from seasoned pros to beginners laser beam device is disposed in the housing for emitting a laser beam to serve as a reference indication line along which a golf ball is to travel. The laser beam projects a linear array of laser dots perpendicular to the putters”Sweet Spot The putting aid is not only good for putters alignment but for all club’s, It clips to all clubs.

WHAT IS”INT”&CON?

In the side panel of the putting aid, there is a little switch indicate modes of light-time. In”INT-Intermittent”mode, the light beam last for 10 seconds only. It is a power-save device for an advanced golfer or a pro . In”CON-Continuous”mode. the light beam is always lighted up unless being switched to”INT”mode.

In”CON”switch mode, the voltage of batteries may be lowered after 30-45 minutes operation. If the laser beam becomes dim please place the laser in a safe place for 1 hour. The laser can be used again after the recovery of the power. After retrieving power 3-4 times, the batteries may need to be replaced. The batteries life is much endurable in”INT”mode.

Press the gap of the clip into the lower part of shaft and slide it upward until it is tightly secured against the shaft. A self-adhesive adapter is prepared for a thin shaft, it is packed with the Clip

Works great for both right and left handed golfers
Easily attaches to all golf putters
Give a laser guide line during your putt to check your putting plane
Fix your putt in seconds
Instructions: INT(automatic model)—turn to INT model and press the pink button,the laser will last 10 seconds and then power off automaticaly;  CON(continuous model)—turn to CON model and press the pink button , the laser will last about 35-40 muinutes, then the voltage will decrease,laser will also becomes weak, close it  for 1 hour, all will be normal again, but we suggest that don’t use CON model except adjusting the angle